Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGhost Controls Gate Motor & Opener in North Hollywood: What to Know First
We repair and install Ghost Controls gate motors and openers throughout North Hollywood, and we do it as an independent Ghost Controls service provider, not a factory affiliate. Most Ghost Controls motor work in North Hollywood wraps up in one visit, and you’ll know the exact price in writing before we touch a single bolt. If your Ghost Controls opener is dead, grinding, swinging past its limits, or refusing to close after the winds off the 170, call (213) 566-1045 and we’ll tell you straight what it’s likely to be.
This page is for homeowners in North Hollywood who already own a Ghost Controls system, or are considering one, and want to know what actually goes wrong with these motors, what it costs to fix them here, and whether the repair is worth doing. We work on the whole Ghost Controls lineup, alongside LiftMaster, Mighty Mule, DoorKing, and six other major brands, so we’re never going to pressure you into a replacement just because it’s convenient for us.
How Ghost Controls Products Fail - and How We Fix Them
- AXDP and AXD series swing-arm motors: the limit switch drift problem. Ghost Controls swing actuators use internal magnetic limit switches, and after a few years of daily cycling on a North Hollywood driveway, those limits creep. The gate starts slamming into the close stop or stopping two feet short of full open. We open the arm, reset the magnetic trip points, and photograph the new positions so the next technician never has to re-diagnose it. That photo log is part of every visit, filed under Haven Standard Clause 4.
- TSS1 and TDS2 slide gate motors: capacitor failure in the heat. North Hollywood summers push 100-plus degrees on an asphalt driveway, and the start capacitor in Ghost Controls slide operators takes the brunt of it. The motor hums but won’t move the gate. We test the capacitor on-site, replace it with an OEM or equivalent-spec aftermarket unit, and check the run capacitor while we’re in there. It’s a $60-to-$120 part that people wrongly assume means a full motor replacement.
- Rural gate kits with the battery tray: the solar-undercharge spiral. Ghost Controls battery-backed systems depend on a consistent charging cycle. In North Hollywood, shade from mature ficus trees along the fence line means the solar panel never fully tops off the battery. The gate works for a month, then goes dead after a two-week stretch of overcast mornings. We test the actual charging voltage at the battery terminals, reposition or upgrade the panel, and set the control board’s low-voltage cutoff correctly.
- Receiver and remote pairing loss after power flickers. Ghost Controls control boards hold their remote codes in memory, but a hard brownout from LADWP during a Santa Ana wind event can corrupt the board’s eeprom. The motor runs fine from the manual button, but every remote stops working. We re-flash and re-pair the receiver, then install an inline surge protector so the next wind event doesn’t wipe the board again.
- Photo-eye misalignment on TDS2 slide installations. The infrared beam that stops the gate when a kid or a car crosses the path gets knocked out of alignment by landscape work, fence repair, or just soil shifting under the photo-eye post. The gate reverses every time it tries to close. We re-align the beam, re-secure the post, and leave you with a written record of the beam gap setting in hundredths of an inch.
Our Ghost Controls Gate Motor & Opener Process
- 1
Call and describe the symptom. A live person answers at (213) 566-1045, any hour. Tell us what the gate is doing or not doing. We’ll tell you what it’s likely to be and what it’ll cost to diagnose.
- 2
On-site diagnostic with a written finding. Our technician arrives in a marked vehicle, name and photo sent before arrival. We test the motor, board, limits, battery, and photo-eyes. You get a written list of what we found.
- 3
Flat price before any work. Haven Standard Clause 1: the written price is in your hand before we pick up a tool. No “call for a quote,” no surprise invoice.
- 4
Parts decision: OEM or quality aftermarket. We carry Ghost Controls OEM parts alongside equivalent-spec aftermarket components. We show you the part number and price for both, and you choose.
- 5
Repair and re-set. We install the part, reset limits and travel, re-pair remotes, re-align photo-eyes, and torque everything to spec. Then we cycle the gate ten full opens and closes while we watch.
- 6
Documentation before we leave. You get a photo log of every adjustment, the part number installed, limit-switch readings, and a written warranty on the work. The 365-Day Done Right Promise covers every repair for one full year.
BeforeAfterWhat Ghost Controls Gate Motor & Opener Costs in North Hollywood
Ghost Controls parts are cheaper than most, and the labor on their swing-arm kits is straightforward, which keeps pricing honest here in North Hollywood. What moves the number is whether we’re replacing the entire actuator or just a board, a capacitor, or a set of limits.
- Full swing-arm actuator replacement (AXDP or AXD): $425-$680 installed, depending on whether the arm bracket and mounting post are intact.
- Slide motor replacement (TSS1/TDS2): $560-$840 installed, including chain or belt re-tensioning and limit re-set.
- Control board replacement: $180-$320 installed, including re-pairing all existing remotes and keypads.
- Capacitor replacement: $95-$160 installed, tested on-site before we call it done.
- Photo-eye realignment or replacement: $90-$180, depending on whether the housing is cracked.
- Battery replacement for backup systems: $110-$210, plus a charging-voltage test so it doesn’t die again in six months.
Every price above is a flat quote. It’s written and agreed before any work starts. Call (213) 566-1045 and we’ll give you an exact number after a diagnostic. Estimates are free.
Why North Hollywood Homeowners Call Vance Gate Repair North Hollywood for Ghost Controls Work
Adrian Vance built this company on commercial access-control work starting in 2014, and the habit that carried over is documentation. On every Ghost Controls job in North Hollywood, you get a written price before the work starts and a photo record when it’s done. No other gate company in the valley works that consistently this way.
We service all nine major gate-automation brands, so when a Ghost Controls system is paired with an older LiftMaster keypad or a Mighty Mule receiver, we fix the whole setup, not just the part with the Ghost Controls name on it. The 365-Day Done Right Promise covers everything we touch, and a live person answers the phone 24 hours a day. No voicemail loop. No callback window.
Name what you found. Name what it costs. Leave the gate straight. That’s how Adrian Vance runs a Ghost Controls call, and it’s why the blocks near North Hollywood Park keep calling.
FAQs
No. As an independent Ghost Controls service provider, we use OEM parts when they’re available, and our work doesn’t void the warranty on your existing hardware. If your unit is still under warranty, we’ll tell you which repairs are covered and which parts you should source from Ghost Controls directly before we spend any of your money.
In most cases, yes. Capacitor replacements, limit re-sets, remote re-pairing, and photo-eye realignments are same-day fixes for us in North Hollywood. If we need to order a specific OEM actuator or board, we’ll tell you the lead time before you agree to anything. Call (213) 566-1045 and we’ll tell you which category your problem falls into.
If the arm, the board, and the power supply are all original and all failing at once, replacement is usually the better call. But that’s rare. Most Ghost Controls failures we see in North Hollywood are a single component, a capacitor, a limit switch, a board, or a photo-eye, and the repair costs a fraction of a new system. We’ll show you the numbers for both options in writing and let you decide.
Slide-gate capacitor failure from the heat and swing-arm limit drift from daily cycling. We see those two more than anything else in North Hollywood, especially on properties with unshaded driveways that bake all afternoon. Both are repairable in one visit and neither is a reason to replace the whole opener.
Yes. We install Ghost Controls swing and slide operators on existing residential gates throughout North Hollywood, and we handle the full setup: mounting, arm travel, limit setting, photo-eyes, remote programming, and the optional battery backup. You get a written quote for the full install before any equipment is ordered, and a documented photo record when the job is done.
Written by Adrian Vance, Owner & Lead Technician, Vance Gate Repair North Hollywood at Vance Gate Repair North Hollywood, serving North Hollywood and nearby areas.