FAAC Gate Motor & Opener Nationwide

FAAC Gate Motor & Opener in North Hollywood: What to Know First

FAAC gate motor and opener repair in North Hollywood is a core part of our service week. Most FAAC jobs we handle are diagnosed and repaired in a single visit, with the written price handed to you before any tool touches the gate. For swing-gate motor replacements, expect most FAAC work to land between $650 and $1,450 depending on the series and whether the arm bracket and mounting plate are reusable.

Call (213) 566-1045

This page is for homeowners in North Hollywood who own a FAAC operator and want straight answers about what fails, what it costs, and whether the motor is worth saving. We service the full FAAC lineup that shows up on residential driveways here, from the older 750 and 760 swing operators to the C720 and S800 slide series. Call (213) 566-1045 and a live person answers, day or night.

How FAAC Products Fail - and How We Fix Them

FAAC builds a solid operator. But every brand has a pattern, and after a decade of opening FAAC control boxes across North Hollywood, we know exactly what to look for before the multimeter even comes out.

• Oil leakage on 750/760 swing operators. These hydraulic units run for years, but the shaft seal eventually dries and weeps. The gate gets slower first, then stops holding position. We replace the seal and refill with the correct FAAC hydraulic fluid rather than plugging in whatever is on the truck. A leaking 750 is usually a $240 to $390 repair, not a replacement.
• Capacitor failure on C720 and C721 slide motors. The C720 series uses a start capacitor that degrades in heat, and North Hollywood summers test every component bolted to a metal post. The symptom is specific: the motor hums but the gate does not move. We replace the capacitor, check the thermal overload, and test the motor under load before calling it fixed.
• Limit switch drift on older FAAC 400 and 412 operators. These are workhorses, but the mechanical limit cams wear over time. The gate slowly overshoots its open and close positions. We reset the cams, photograph the new positions, and add that to your job record so the next service call starts from a known point.
• Board failure from power surges on FAAC E024U control boards. This board controls a lot of FAAC residential operators, and it does not forgive a voltage spike. The gate simply stops responding to remotes or the keypad. We check the board for burned traces on the transformer input first, because that determines whether we replace the board or repair the circuit. A board replacement runs $380 to $620 installed.
• Receiver range loss on FAAC 433 MHz systems. North Hollywood homeowners with FAAC remote receivers often report the remote only works within ten feet of the gate. The usual cause is antenna placement inside a metal control box, not the remote itself. We relocate or extend the antenna and retest from the street at 30 and 60 feet, then document the range achieved.

Our FAAC Gate Motor & Opener Process

Every FAAC job follows the same sequence, whether it is a motor replacement on a C720 slide or a board repair on a 760 swing operator.

1. 1
   You call (213) 566-1045. A live person answers. We ask what the gate is doing, what series of FAAC operator you have if you know it, and when you need it addressed. No callback queue.
2. 2
   We arrive and diagnose. The technician checks the operator, the control board, the limit settings, and the physical gate itself. Roughly a third of FAAC “motor failures” turn out to be a gate that binds or a photo-eye misaligned by half an inch.
3. 3
   You get a written price. Before any work starts, we hand you a scope of work with a flat price. That is Haven Standard Clause 1, and it applies to every FAAC repair no matter how small.
4. 4
   We do the work with the right parts. Where warranty-sensitive components are involved, we use FAAC OEM parts. For non-critical hardware, we explain what we are installing and why. You agree before we order or install anything.
5. 5
   We test the full cycle. Open, close, obstruction reversal, photo-eye interruption, remote range, and battery backup if equipped. We run the gate through at least ten full cycles before we call it done.
6. 6
   You get the photo record. What we found, what we set, what we replaced. Every adjustment documented. If anything acts up within 365 days, we correct it at no charge under the Done Right Promise.

Before

After

What FAAC Gate Motor & Opener Costs in North Hollywood

We price in writing, and the range depends on what the gate actually needs. Here are the numbers we quote most often in North Hollywood:

• FAAC 750/760 hydraulic seal repair: $240 to $390
• C720/C721 capacitor and start circuit repair: $180 to $320
• E024U control board replacement: $380 to $620
• Full swing motor replacement (FAAC 750/760 or current equivalent): $650 to $1,450 depending on arm bracket condition and whether the hydraulic lines are reusable
• Slide motor replacement (FAAC C720/S800): $900 to $1,800 depending on rack condition and whether the magnetic limit system needs replacing
• Receiver upgrade or antenna relocation: $120 to $240

What moves the price is the series you own, whether the mounting hardware survived, and whether the control board is reusable. We tell you the number before work begins, not after. Call (213) 566-1045 and ask for a free estimate on your FAAC operator.

Why North Hollywood Homeowners Call Vance Gate Repair North Hollywood for FAAC Work

We are an independent FAAC service provider, not an authorized dealer, and that independence matters. We do not steer you toward a full operator replacement when a $210 capacitor would fix the issue. We do not work on commission for any manufacturer. Our only incentive is doing the repair correctly the first time.

The 365-Day Done Right Promise covers every FAAC job we complete in North Hollywood. If something is not right within that year, we return and fix it at no additional charge. No argument, no fee, no expiration date inside that window. And because we also service LiftMaster, Mighty Mule, Ghost Controls, and DoorKing, we can tell you honestly whether your FAAC unit is worth repairing or whether the motor on the adjacent gate tells a different story. Adrian Vance has been running these calls since 2014, and the technicians he sends are background-checked and uniformed. You know who is coming before they arrive.

FAQs